Fwd: serial port issue

[Jorid]

---------- Forwarded message ----------
From: Jorid <joridporeci at gmail.com>
Date: Jul 14, 2007 6:02 PM
Subject: Re: serial port issue
To: Kn1ght L0rd <kn1ghtl0rd.01 at gmail.com>



On 7/14/07, Kn1ght L0rd <kn1ghtl0rd.01 at gmail.com> wrote:

> Jorid,
>
> Why are you flashing the firmware using the serial cable anyway?  My
> understanding is the only reason to use that is if you are changing the
> sam7dfu.  You use dru-programmer to upload new firmware which just uses the
> normal USB cable.  I too am playing with the same unit and I am designing
> firmware for it so I have been doing tons of research into embedded systems
> programming and the openPCD device.  I was just curious of your reasoning so
> I can possibly add it to my research.  Thanks.
>
> Milosch,
>
> I don't know if your email system is blocking my emails or not but I have
> sent you two emails that you have not responded to and usually you respond
> the next day.  I just want to make sure that you are getting my
> communications alright.  If I need to use another email address I can.  Let
> me know.  Thanks.
>
>
>
>
> On 7/14/07, Milosch Meriac <meriac at bitmanufaktur.de > wrote:
> >
> > Dear Jorid,
> >
> > Jorid wrote:
> > > have a problem . My box recognizes the usb device lsusb Bus 001
> > > Device 006: ID 03eb:6124 Atmel Corp.
> > >
> > > but when i typeoptions usbserial vendor=0x03EB product=0x6124
> > >
> > > dmesg | grep ttyUSB
> > >
> > > nothing comes out. any idea??
> >
> > Have you added "options usbserial vendor=0x03EB product=0x6124" to your
> > modprobe.conf(.local) ? according to
> > http://wiki.openpcd.org/index.php/Firmware ?
> >
> > Also make sure that the module subserial is actually loaded:
> >
> > # modprobe usbserial
> >
> > a quick way to check:
> > # rmmod usbserial
> > # modprobe usbserial vendor=0x03EB product=0x6124
> >
> > Warmest regards,
> >
> > Milosch Meriac
> > --
> > Bitmanufaktur :: Schwedter Strasse 23 :: 10119 Berlin
> > Fon +49 (0)30 4172 5006 :: Fax +49 (0)30 4172 5054
> > meriac at bitmanufaktur.de :: http://bitmanufaktur.de
> >
> > Thank you for your quick responses. I got your emails but i wasn't on my
> computer for a while.
>



Anyway i am flashing the flash image because by MISTAKE without reading the
> hardware manual I flashed the image by inserting the pins. When i bought the
> RFID reader was working fine , when i plugged it to my usb-port I had the
> led working. After that there was no light at all because of my stupid
> error.
>

i did follow you command  and know  I am able to  identify the serial port i
needed .  Many thanks again for your time .
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.openpcd.org/pipermail/openpcd-devel/attachments/20070714/beef6ce3/attachment.html